For new versions please make sure that you are enabled full access to PLC.
Also check that permit access, otherwise you will receive error 123 from PLC
- New Bitmap Image.jpg (303.42 KiB) Viewed 43258 times
Search found 3 matches
- Fri Feb 20, 2015 10:46 am
- Forum: Controller Communication
- Topic: Comm error stn 0
- Replies: 7
- Views: 44986
Re: Comm error stn 0
For Siemens 1200, 1500 users
For new versions please make sure that you are enabled full access to PLC.
Also check that permit access, otherwise you will receive error 123 from PLC
For new versions please make sure that you are enabled full access to PLC.
Also check that permit access, otherwise you will receive error 123 from PLC
- Fri Feb 20, 2015 10:19 am
- Forum: Controller Communication
- Topic: T7A with Omron CP1 connection
- Replies: 1
- Views: 11529
Re: T7A with Omron CP1 connection
As i know you can not access that area.
You should use other areas.
You should use other areas.
- Fri Feb 20, 2015 10:17 am
- Forum: Controller Communication
- Topic: Communication problems between IX and Siemens S7-1500
- Replies: 4
- Views: 21302
Re: Communication problems between IX and Siemens S7-1500
HELLO, I also met the problem it is already necessary to put in ix Developer the slot to 1 in the parameters of communication. Then in TIA Portal it is necessary to go to the cpu and to the properties / protection and checked the box all below to authorize the exchanges towards a HMI. ScreenHunter_...