Dear all
I am using X2 Extreme 7 with MIRI PLC on Modbus communication. Two times, HMI is getting rebooted itself and frozen before application loaded, as image below. Then, I need turn off the HMI and, seconds later turn on it and works correctly.
What could be the problem?
Awaiting your reply
Regards
X2 Extreme 7 Froze
-
Aby.Marcelo
- Posts: 1
- Joined: Wed Nov 27, 2019 11:13 am
X2 Extreme 7 Froze
- Attachments
-
- HMI froze.jpg (78.39 KiB) Viewed 8923 times
Re: X2 Extreme 7 Froze
It looks like you're on an older version of the firmware, can you try updating the latest firmware using the "Recovery SD Card" option?
Best regards,
Russ
(801) 708-6690
Technical Support
Contact Us
Beijer Electronics AB
http://www.beijerelectronics.us
Russ
(801) 708-6690
Technical Support
Contact Us
Beijer Electronics AB
http://www.beijerelectronics.us
-
AMitchneck
- Posts: 137
- Joined: Mon Jun 11, 2012 2:10 pm
Re: X2 Extreme 7 Froze
I had the same issue, along with the Ethernet port freezing. Updating firmware to the latest version fixed my issues.
Adam M.
Controls Engineer
FlexEnergy
Controls Engineer
FlexEnergy