TxA Transformation problem
Posted: Mon Nov 04, 2013 2:48 am
Hi there,
Our customer is using both T7A and T10A panels. Because of switching the target is very easy, i'm developing the project on an T7A target.
But I found that the "WordWrap" property is missing after transformation of targets! I think I also had this problem before with the "MultiLine" property!
Is there already a solution for this phenomen? We are still developing on new features while first versions are going out to the customers, and we cannot go through the whole project everytime after transformation and correct the properties!
As always, thanks for the support!
Our customer is using both T7A and T10A panels. Because of switching the target is very easy, i'm developing the project on an T7A target.
- T7A before conversion.png (198.34 KiB) Viewed 5225 times
- T10A after conversion.png (120.79 KiB) Viewed 5225 times
As always, thanks for the support!