Crash on build

Discussion of application development using iX Developer, including but not limited to getting started, using the functions tab, properties, objects and installation.
Post Reply
dleblanc
Posts: 1
Joined: Mon May 18, 2015 10:13 am

Crash on build

Post by dleblanc »

I keep on getting this crash when attempting to build a specific project, the only obvious difference is I need to use serial modbus communication for this one (used to work fine), I usually work with modbus TCP. Project and log file attached, any clue what's going on?
Pop Up screen capture
Pop Up screen capture
Error.JPG (79.03 KiB) Viewed 6629 times
Attachments
GAB0440_04052015.zip
Project
(96.5 KiB) Downloaded 944 times
NeoIDELog.zip
Log file
(1.92 KiB) Downloaded 765 times

User avatar
Kyle W.
Posts: 36
Joined: Wed Apr 09, 2014 3:16 pm

Re: Crash on build

Post by Kyle W. »

I downloaded and ran your project. Is this a new installation of iX Developer? The most common cause of that error is when iX Developer is installed using the NeoSetup.msi instead of the Setup.exe (see this link: http://ixtalk.beijerelectronics.com/vie ... f=7&t=1766). NeoSetup only installs the iX shell without the necessary .NET framework.
Best Regards,

Kyle W. | Applications Engineer
Beijer Electronics, Inc.

Post Reply