Page 1 of 1
Crash on build
Posted: Mon May 18, 2015 10:40 am
by dleblanc
I keep on getting this crash when attempting to build a specific project, the only obvious difference is I need to use serial modbus communication for this one (used to work fine), I usually work with modbus TCP. Project and log file attached, any clue what's going on?
- Pop Up screen capture
- Error.JPG (79.03 KiB) Viewed 6632 times
Re: Crash on build
Posted: Thu May 28, 2015 3:28 pm
by Kyle W.
I downloaded and ran your project. Is this a new installation of iX Developer? The most common cause of that error is when iX Developer is installed using the NeoSetup.msi instead of the Setup.exe (see this link:
http://ixtalk.beijerelectronics.com/vie ... f=7&t=1766). NeoSetup only installs the iX shell without the necessary .NET framework.