There are several similar machines, different only in IP addresses.
Is it possible to read a display own IP address on boot, and use it to assign the necessary target controller IP address?
Assigning the target controller IP address programmatically
-
Sergei Troizky
- Posts: 23
- Joined: Mon Jun 13, 2016 4:03 pm
-
Gabriel B.
- Posts: 13
- Joined: Mon Nov 06, 2017 11:19 am
Re: Assigning the target controller IP address programmatica
Hi Sergie,
You are able to map the IP addresses to appropriate contollers using a ".db" file and upload it to the iX project. You can write a script to check/align IPs with Controllers on startup. If an IP address were to change on a panel, the panel will reboot with the correct mapping indicated from the ".db" file.
You are able to map the IP addresses to appropriate contollers using a ".db" file and upload it to the iX project. You can write a script to check/align IPs with Controllers on startup. If an IP address were to change on a panel, the panel will reboot with the correct mapping indicated from the ".db" file.