Page 1 of 1
TA 150
Posted: Thu Aug 15, 2013 4:50 am
by Ilya_Turlo
Hello, we have panel TA 150 with installed project, connected with B&R x20 cp84. How communicate with panel through OPC server not to uploading the project from panel? Help please.
Re: TA 150
Posted: Thu Aug 15, 2013 5:42 am
by mark.monroe
Here is a
forum post that talks about the OPC server on our HMI panels. I can only help if you provide a detailed description of your complete setup including IP addresses and what exactly is going wrong.
Re: TA 150
Posted: Fri Feb 09, 2018 12:39 pm
by Maj
Hi
I hope this reach you
We have the same here TA150 and connected to B&R x20cp1484-1, and there problem with communication sometimes but when I take the sd card out and put back I get communication but I get an error 1E0 on the panel which says main intialization not done , any idea? Also Is there away to connect to the project in the panel which I bileve I can't access it , I tried upload from the target using cross over cable but the download button is gryied so no way ,
Any advice please
Thank you very much