Connecting omron plc through ix t7a

Discussion of configuring and troubleshooting communication to PLC's or other devices using iX Developer.
Post Reply
GKMN
Posts: 1
Joined: Fri Jun 27, 2014 1:41 pm

Connecting omron plc through ix t7a

Post by GKMN »

Hi,

I have omron cj1m cpu11 plc and ix t7a panel. They comminicate with rs232 cable. I want to connect to my plc through ix t7a, and i didn't succeed.
I am using fins protocol and ix t7a panel communicates well with plc.There is no problem. When i try to connect from cx-programmer(omron plc software) to plc, it writes on the panel ''controller1:passthrough ''. Then cx-programmer says ''selected port does not exist'' .
My question is did you try to connect to omron plc's this way? If you did, pls give me hand.
Attachments
fins ayar3.jpg
fins ayar3.jpg (56.98 KiB) Viewed 7680 times
fins ayar2.jpg
fins ayar2.jpg (55.46 KiB) Viewed 7680 times
fins ayar1.jpg
fins ayar1.jpg (58.17 KiB) Viewed 7680 times

User avatar
Russ C.
Posts: 213
Joined: Thu Nov 16, 2017 3:32 pm
Contact:

Re: Connecting omron plc through ix t7a

Post by Russ C. »

Hello,
We understand that this is a very old post. If there is anyone who is still experiencing this or similar issues and require assistance, please visit us at https://www.beijerelectronics.us/en-US/ ... ___support or give us call at 801.708.6690.

Thank you.
Best regards,

Russ
(801) 708-6690
Technical Support
Contact Us

Beijer Electronics AB
http://www.beijerelectronics.us

Post Reply