iX Talk

Hi,

I have omron cj1m cpu11 plc and ix t7a panel. They comminicate with rs232 cable. I want to connect to my plc through ix t7a, and i didn't succeed.
I am using fins protocol and ix t7a panel communicates well with plc.There is no problem. When i try to connect from cx-programmer(omron plc software) to plc, it writes on the panel ''controller1:passthrough ''. Then cx-programmer says ''selected port does not exist'' .
My question is did you try to connect to omron plc's this way? If you did, pls give me hand.

Hello,
We understand that this is a very old post. If there is anyone who is still experiencing this or similar issues and require assistance, please visit us at https://www.beijerelectronics.us/en-US/ ... ___support or give us call at 801.708.6690.

Thank you.