VNC for two operators

A forum devoted to the discussion of all topics having to do with scripting and other advanced programming using iX Developer.
Post Reply
JohnCZ
Posts: 73
Joined: Wed Jun 27, 2012 1:17 am
Location: CZ
Contact:

VNC for two operators

Post by JohnCZ »

Hi,

I wanted to ask if it is possible when I log as the VNC client to the panel, so the operator, which is near-panel, will have on screen "momentary remote access is done"
This will see Operator when I will be connect via VNC to the panel
This will see Operator when I will be connect via VNC to the panel
ThisWillseeOperator.JPG (28.08 KiB) Viewed 7081 times
But to the one who is logged on via VNC , will work normally with panel and can modify some parameters.
This will see if I will be connected to a VNC
This will see if I will be connected to a VNC
VNCscreen.JPG (33.57 KiB) Viewed 7081 times


JohnCZ

mark.monroe
Posts: 824
Joined: Tue Mar 13, 2012 9:53 am

Re: VNC for two operators

Post by mark.monroe »

No, that is not possible. VNC works by mirroring the HMI screen. There is no way to have the VNC show something different than what is on the HMI.

You can use the webserver to do what you want. But you would have to create the webpages by hand. iX Developer does not have any features that help in the creation of those webpages.
Best Regards,
Mark Monroe

Beijer Electronics, Inc. | Applications Engineer

JohnCZ
Posts: 73
Joined: Wed Jun 27, 2012 1:17 am
Location: CZ
Contact:

Re: VNC for two operators

Post by JohnCZ »

Ok thanks

Post Reply