Context menu in Alarm Viewer

[cybermen]

Hi All,
The right mouse button is often used to open contextual menus, which are pop-up menus that change depending where you click.
I removed "Clear"button from Alarm Viewer screen, but...
for "advanced" HMI operators I need to remove "Clear" from Context Menu. How to do it?
Thanks,
Ilgonis

[mark.monroe]

You can only enable or disable the context menu. There is currently no way to edit it.

[cybermen]

Hi Mark,
Thanks for the answer!
In this case, maybe there is a way to assign Security Group Restrictions for "Clear" button?

[mark.monroe]

Unfortunately you can not set security groups on buttons in the Alarm Viewer.

[cybermen]

Here is my version of security groups on buttons in the Alarm Viewer.
Of course it is stupid and probably wrong way, but if Beijer Electronics support does not offer a better solution...

I recorded this in a video and can be viewed with Webex tool (freely downloadable from the internet).
Below i attached video file (Clear_1) and player setup file (atrecply).

Regards,
Ilgonis

[cybermen]

Ok,
Here is simple way to solve problem:
1) create tag to clear alarms (in Alarm Server Settings tab);

ScreenShot013_1.png (113.94 KiB) Viewed 13883 times

2) uncheck from respective boxes (in Alarm Wiewer General tab);

ScreenShot014_1.png (71.16 KiB) Viewed 13883 times

3) create button called 'Clear";
4) set security for this button in Tag/Security;

ScreenShot015_1.png (97.38 KiB) Viewed 13883 times

Done.

Only one question ( in next post).

Regards,
Ilgonis

[cybermen]

Only one question: how to make button 1:1 as in Alarm Viewer.

In picture attached below:
Button1 made from Buttons selection (simply, but impossible to repeat as in Alarm viewer),
Button2 (1:1 as in Alarm Viewer) made from combination of rectangle & text (all ok, but button is complicated).

ScreenShot016_1.png (81.89 KiB) Viewed 13883 times

Regards,
Ilgonis