iXT7B communication Break issue with Fx3U PLC

Discussion of configuring and troubleshooting communication to PLC's or other devices using iX Developer.
Post Reply
mei_india
Posts: 10
Joined: Tue Feb 26, 2013 3:58 am

iXT7B communication Break issue with Fx3U PLC

Post by mei_india »

Dear Sir/Ma'am

We are facing communication break issue in iXT7B and FX3U PLC in following conditions.
1.In proper communication condition when you switch off iX panel and again power ON it after 1Hr or so, "comm. error" is displaying on screen. Then you need to connect and disconnect communication cable several times to start communication again. Same issue on both com2 and com4 port.
2.We also done self test after communication break. Please check self test result attached.
3.please find attachment for Communication parameter set in iX panel settings. Cable configuration is also proper.

So please let us know
Is it hardware issue? or any other settings required for the same.

thanks in advance.
Attachments
Controller Setting in iX Panel
Controller Setting in iX Panel
Settings1.gif (41.13 KiB) Viewed 8750 times
iX Panel Self Test Snap2
iX Panel Self Test Snap2
IMG-20140121-WA0002.jpg (48.58 KiB) Viewed 8750 times
iX Panel Self Test Snap1
iX Panel Self Test Snap1
IMG-20140121-WA0001.jpg (47.95 KiB) Viewed 8750 times
Top
stuartm
Posts: 61
Joined: Thu Jun 06, 2013 9:21 am

Re: iXT7B communication Break issue with Fx3U PLC

Post by stuartm »

Please provide a wireshark or serial comm printout and send it into support@beijerinc.com

Thank you.
Top
Post Reply

Return to “Controller Communication”