DElta DTC 1000 Addressing

Discussion of configuring and troubleshooting communication to PLC's or other devices using iX Developer.
Post Reply
ingoharj
Posts: 5
Joined: Wed Feb 05, 2014 5:07 am

DElta DTC 1000 Addressing

Post by ingoharj »

Hi,
I am using Delta DTC1000 & Delta DTC2000 in parallel it is on RS485,
I have selected Delta - Modbus slave ASCII protocol,
Node address 01H, 02H & 03H,
& I need to Read/write at address 1000H, 1001H, 1009H, 100AH, 100BH
Can I have sample address,

I have tried 01:1000H , 01H:1000H, its not working,
Regards,

Arjun
Top
ceyhanv
Posts: 1
Joined: Fri Feb 27, 2015 4:12 pm

Re: DElta DTC 1000 Addressing

Post by ceyhanv »

ingoharj wrote:Hi,
I am using Delta DTC1000 & Delta DTC2000 in parallel it is on RS485,
I have selected Delta - Modbus slave ASCII protocol,
Node address 01H, 02H & 03H,
& I need to Read/write at address 1000H, 1001H, 1009H, 100AH, 100BH
Can I have sample address,

I have tried 01:1000H , 01H:1000H, its not working,
Regards,

Arjun
Top
Post Reply

Return to “Controller Communication”