Hi,
I have a setup with 3 languages.
I'm trying to change the system texts on an analog numeric with limit on input.
By default it says:
Error
Input value out of range
Must be between 0 and 100
No matter what I write in the new language the Error and Must be between 0 and 100 never change...
Only the the Input value out of range gets changed...
Any idea?
Multiple language problem
Re: Multiple language problem
Hello,
We understand that this is a very old post. We would need to take a look at your project to get a better idea of why it is causing this issue. I imagine it would have something to do with the data types of the analog value. If there is anyone who is still experiencing this or similar issues and require assistance, please visit us at https://www.beijerelectronics.us/en-US/ ... ___support or give us call at 801.708.6690. Thank you.
We understand that this is a very old post. We would need to take a look at your project to get a better idea of why it is causing this issue. I imagine it would have something to do with the data types of the analog value. If there is anyone who is still experiencing this or similar issues and require assistance, please visit us at https://www.beijerelectronics.us/en-US/ ... ___support or give us call at 801.708.6690. Thank you.
Best regards,
Jason
(801) 708-6690
Technical Support
Contact Us
Beijer Electronics AB
http://www.beijerelectronics.us
Jason
(801) 708-6690
Technical Support
Contact Us
Beijer Electronics AB
http://www.beijerelectronics.us