No working driver for Fanuc Robotics?

[TommyWedell]

Will try again, my last post dissapeared.

I have serious problems with data transfer between my iX T15b panel, and the Fanuc Robot controller 30iB. Digital I/O works well, but data registers are not working properly. (driver GE/Fanuc Ethernet via SRTP)
Problem 1: It´s not possible to send decimal values. The values will be rounded up/down to closest number. This causes lot of problems.
Problem 2: Data registers cannot be more than 4 digits. This is very big problem. Register handling will be unusable!

Answers on that from Beijer? Is this driver tested with Fanuc Robots?

Fanuc support says that this must be caused by the driver (GE Fanuc is an old PLC system, and shall not be compared and not simlilar to Fanuc Robotics)

[Russ C.]

Hello,

We understand that this is a very old post. If there is anyone who is still experiencing this or similar issues and require assistance, please visit us at https://www.beijerelectronics.us/en-US/ ... ___support or give us call at 801.708.6690.

Thank you.